![]() ![]() Requirement already satisfied: numpy>=1.16 in /Library/Frameworks/amework/Versions/3.9/lib/python3.9/site-packages (from pyjls) (1.22.4)īuilding wheels for collected packages: pyjlsīuilding wheel for pyjls (setup.py). If executing pip with sudo, you should use sudo's -H flag. Check the permissions and owner of that directory. ![]() WARNING: The directory '/Users/michael/Library/Caches/pip' or its parent directory is not owned or is not writable by the current user. ![]() Note: valid target CPU values are: nocona, core2, penryn, bonnell, atom, silvermont, slm, goldmont, goldmont-plus, tremont, nehalem, corei7, westmere, sandybridge, corei7-avx, ivybridge, core-avx-i, haswell, core-avx2, broadwell, skylake, skylake-avx512, skx, cascadelake, cooperlake, cannonlake, icelake-client, rocketlake, icelake-server, tigerlake, sapphirerapids, alderlake, knl, knm, k8, athlon64, athlon-fx, opteron, k8-sse3, athlon64-sse3, opteron-sse3, amdfam10, barcelona, btver1, btver2, bdver1, bdver2, bdver3, bdver4, znver1, znver2, znver3, x86-64, x86-64-v2, x86-64-v3, x86-64-v4Įrror: command '/usr/bin/gcc' failed with exit code 1įull log: pyjoulescope_examples % sudo pip3 install -U pyjls I get the below error after running: sudo pip3 install -U pyjlsĮrror: error: unknown target CPU 'armv8-a crc simd' The UI works fine but can’t get this python lib to install. It should take just a few seconds to complete execution.I’m trying to install pyjls and joulescope on my M1 Macbook. The final step here is to execute - sudo make install. After it’s done you should get an output like so. You can adjust the j option with respect to the hardware available. With all the eight cores ( j8 stands for eight cores here) chugging along, this step took ~8 minutes for me. Next, we launch the make command - make -j8. The compilation took ~3 minutes for me and it should produce outputs like so. Now, before you run the above cmake command, activate the conda environment you created in an earlier step ( conda activate ) if you haven’t already. ![]() For these two arguments, you would want to first determine the paths and then supply them accordingly. Also, please pay attention to the following arguments - OPENCV_EXTRA_MODULES_PATH and PYTHON3_EXECUTABLE. D PYTHON3_EXECUTABLE =/Users/sayakpaul/miniforge3/envs/dev/bin/python3 \Īs per this issue comment, DCMAKE_SYSTEM_PROCESSOR, DCMAKE_OSX_ARCHITECTURES, DWITH_OPENJPEG, and DWITH_IPP are needed to be set during the compilation step. D OPENCV_EXTRA_MODULES_PATH =/Users/sayakpaul/Downloads/opencv_contrib-4.5.0/modules \ ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |